Mst Instance Configuration - Panasonic PN261693D Manual

4.4.6.

MST Instance Configuration

Press M (command) and enter an MST instance ID on MSTP Instance
Configuration. After that, you can see the MST Instance Configuration as Figure 4-
21 below. You can implement the advanced settings for the MST instance on this
screen.
PNxxxxxx Local Management System
MST Instance Configuration -> MST Instance Configuration
MSTI Root Port:
MSTI Root Cost:
MSTI Regional Root:0
-------------------------------- <COMMAND> -----------------------------------
Set MSTI Bridge Pr[i]ority
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
MSTI Root Port Displays the route port-number of the MST instance.
MSTI Root Cost Displays the value of route path cost of the MST instance.
Time Since Displays the elapsed time (seconds) after changing the configuration of a
Topology spanning tree.
Change
Topology Displays the number of that configuration of a spanning tree is changed.
Change Count
MSTI Regional Displays an ID of a regional route bridge of the MST instance.
Root
MSTI Bridge ID Displays a bridge ID of the MST instance.
The following describes how to use several commands on this screen.
I Configures a bridge priority of the MST instance.
Press I (command), and then the appearance of the command prompt becomes "Enter
MSTI Priority>". Enter the value of the bridge priority.
Q Returns to the top menu.
0
0
000000000000 MSTI Bridge ID:
Figure 4-21: MST Instance Configuration
Time Since Topology Change: 0
Topology Change Count:
8000 000000000000
103
Sec.
0