Figure 39 Protocol Based Vlan; Table 18 Protocol Based Vlan Setup - ZyXEL Communications ZyXEL Dimension ES-2048 User Manual

ES-2048 User's Guide

Figure 39 Protocol Based VLAN

The following table describes the labels in this screen.

Table 18 Protocol Based VLAN Setup

LABEL
Active
Port
Name
Ethernet-type
VID
Priority
Add
Cancel
Index
Active
Port
Name
Ethernet Type
92
DESCRIPTION
Check this box to activate this protocol based VLAN.
Type a port to be included in this protocol based VLAN.
This port must belong to a static VLAN in order to participate in a protocol based
VLAN. See Section 8.1 on page 81
Enter up to 11 alphanumeric characters to identify this protocol based VLAN.
Use the drop down list box to select a predefined protocol to be included in this
protocol based VLAN or select Others and type the protocol number in hexadecimal
notation. For example the IP protocol in hexadecimal notation is 0800, and Novell IPX
protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff
are not allowed to be used for protocol based VLANs.
Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN
which you defined in the Advanced Applications, VLAN screens.
Select the priority level that the switch will assign to frames belonging to this VLAN.
Click Add to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
This is the index number identifying this protocol based VLAN. Click on any of these
numbers to edit an existing protocol based VLAN.
This field shows whether the protocol based VLAN is active or not.
This field shows which port belongs to this protocol based VLAN.
This field shows the name the protocol based VLAN.
This field shows which Ethernet protocol is part of this protocol based VLAN.
for more details on setting up VLANs.
Chapter 8 VLAN