Static Route Commands - ZyXEL Communications ZyXEL Dimension ES-2048 User Manual

ES-2048 User's Guide
Syntax:
spq
wfq
wrr
fe-spq <Q0-Q7>
where
spq
wfq
wrr
fe-spq <Q0-Q7>
An example is shown next.
• Set the queueing method to SPQ.
sysname(config)# spq

33.6 Static Route Commands

You can create and configure static routes on the switch by using the
Syntax:
ip route <ip> <mask> <next-hop-ip>
ip route <ip> <mask> <next-hop-ip> [metric <metric>][name <name>]
[inactive]
where
<ip>
<mask>
<next-hop-ip>
256
= Sets the queuing method to SPQ (Strictly Priority Queuing).
= Sets the queuing method to WFQ (Weighted Fair Queuing).
= Sets the queuing method to WRR (Weighted Round Robin).
= Sets the switch to use SPQ to service the subsequent
queue(s) after and including the specified queue.
You may want to configure weights for specific queues on
the ports if you use WRR. See the weight command example
in Section 34.2.9 on page
= Specifies the network IP address of the final destination.
= Specifies the subnet mask of this destination.
= Specifies the IP address of the gateway. The gateway is an
immediate neighbor of your switch that will forward the
packet to the destination. The gateway must be a router on
the same segment as your switch.
Chapter 33 Configuration Mode Commands
267.
command.
ip route