Table 36 Port Authentication: 802.1X - ZyXEL Communications ZyXEL Dimension ES-2048 User Manual

ES-2048 User's Guide
The following table describes the labels in this screen.

Table 36 Port Authentication: 802.1x

LABEL
Active
Port
*
Active
Reauthentication Specify if a subscriber has to periodically re-enter his or her username and
Reauthentication
Timer
Apply
Cancel
136
DESCRIPTION
Select this check box to permit 802.1x authentication on the switch.
Note: You must first enable 802.1x authentication on the switch
before configuring it on each port.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this checkbox to permit 802.1x authentication on this port. You must first allow
802.1x authentication on the switch before configuring it on each port.
password to stay connected to the port.
Specify how often a client has to re-enter his or her username and password to stay
connected to the port.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to reset the fields.
Chapter 16 Port Authentication