Table of Contents
Advertisement
11 TUNING THE CHASSIS
11.17
62
M00987-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
M00993-11
(All special models)
On the upper triple clamp, there are 2 holes at a distance
A
of
to each other.
15 mm (0.59 in)
A
Hole distance
The holes on the handlebar supports are placed at a distance
B
of
from the center.
3.5 mm (0.138 in)
B
Hole distance
The handlebar holders can be mounted in four different posi-
tions.
(All standard models)
–
1
Remove screws
. Take off the handlebar clamps.
Remove the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
2
Remove screws
. Take off the handlebar supports.
–
Place the handlebar supports in the required position.
Mount and tighten screws
Guideline
Screw, handle-
M10
bar holder
Info
Position the left and right handlebar supports
evenly.
–
Position the handlebar.
2
.
40 Nm (29.5 lbf ft)
Loctite
®
243™
Advertisement
Table of Contents
