KTM 350 XCF-W 2022 Owner's Manual page 74

12 SERVICE WORK ON THE CHASSIS
72
–
Tighten screws
Guideline
Screw, bottom triple
clamp
V01793-10
–
Tighten screw
Guideline
Screw, top steering
head
–
Mount and tighten screw
Guideline
Screw, top
steering stem
V01794-10
–
Tighten screws
Guideline
Screw, top triple
clamp
V01793-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
V01792-10
Finishing work
–
Insert the fuel tank breather hose into the steering head screw.
–
Mount the handlebar cushion.
–
Install front fender. (
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
6
.
M8 15 Nm (11.1 lbf ft)
4
.
M20x1.5 12 Nm (8.9 lbf ft)
7
.
M8 17 Nm (12.5 lbf ft)
8
.
M8 17 Nm (12.5 lbf ft)
M8 25 Nm (18.4 lbf ft)
bk
.
p. 76)
( p. 115)
p. 131)
Loctite ® 243™
9
.
Loctite ® 243™
p. 129)
p. 73)
p. 64)