12.8
Installing the fork legs
Main work
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
402556-10
(All standard models)
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
V01756-11
triple clamp
(All special models)
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
V01784-11
triple clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
K00546-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
SERVICE WORK ON THE CHASSIS 12
1
are positioned toward the front.
2
.
M8
3
.
M8
2
.
M8
3
.
M8
M8
25 Nm (18.4 lbf ft)
5
.
(
p. 115)
p. 131)
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
17 Nm
(12.5 lbf ft)
15 Nm
(11.1 lbf ft)
4
.
Loctite
®
243™
p. 129)
67