Table of Contents
Advertisement
12.12
Installing the lower triple clamp
–
Install front fender. (
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
(All special models)
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Position the lower triple clamp with the steering stem. Mount
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
Mount protective ring
B01604-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Secure the wiring harness and the clutch line with the cable
holder.
V01787-12
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB
(red adjuster). The compression damping is located in
left fork leg COMP (white adjuster).
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
V01791-10
be flush with the upper edge of the upper triple clamp.
SERVICE WORK ON THE CHASSIS 12
p. 76)
(
p. 115)
p. 131)
p. 171)
1
2
3
and O-ring
.
4
, but do not tighten yet.
5
are positioned toward the front.
p. 129)
p. 73)
p. 64)
is correctly posi-
71
Advertisement
Table of Contents
