Table of Contents
Advertisement
Identifying Controls
Main unit
●
To take out/store the power indicator and remote
control sensor, operate the lever on the rear panel.
It is also possible to press the remote control sensor
directly to store.
Note
●
For normal use, pull out the power indicator and
remote control sensor from the edge side of the
main unit by operating the lever on the rear panel.
Depending on the setup condition such as when
using the multi display, store them in the main unit.
1 Power Indicator / Remote control sensor
The Power Indicator will light.
When the power of the unit is ON (Main Power On
/ Off button: ON)
●
Picture is displayed: Green
●
When the unit enters the standby mode using the
following functions: Orange (Red/Green)
Standby state with the "Power management" function
•
About "Power management" function, see page 45.
Standby state with [HDMI-CEC control] set to
•
[Enable] and at least one [Link function] set to
other than [Disable]
About [HDMI-CEC control] setting and [Link
function], see page 47.
Standby state with [Network control] set to [On]
•
About "Network control" settings, see page 50.
●
Standby state in conditions other than the above: Red
When the power of the unit is OFF (Main Power
On / Off button: OFF): No light
Note
●
Even if the display unit is turned off with the power
indicator off, some of the circuits are in power-on status.
●
When the power indicator is orange, power
consumption during standby is generally larger than
that of when the power indicator is red.
24
English
9
INPUT
MENU
3 4 5
1 External Input Terminal
Connects to video equipment, PC, etc. (see page 15)
2 Main power switch (
Turns OFF (
) or ON ( ) the main power.
Turning ON and OFF the <Main power switch> is the
same as plugging and unplugging the power plug.
Turn ON ( ) the main power first, and then turn
OFF or ON the power using the Power button of the
remote control or the unit.
3 <Main Power On / Off button>
Turns the power Off / On.
4 <INPUT (Unit)>
Selects the connected device. (see page 27)
5 <MENU (Unit)>
Displays the menu screen. (see page 32)
6 <+ (Unit)> / <- (Unit)>
Adjusts the volume. (see page 28)
On the main screen, switches settings or adjusts
settings level. (see page 32)
7 <
(Unit)> / <
(Unit)>
Selects the setting item on menu screen. (see page
32)
8 <ENTER (Unit)>
Configures the item on menu screen. (see page 32)
Switches aspect mode. (see page 30)
9 Built-in speakers
Note
●
To output sound from the built-in speakers of the
unit, be sure to set [Output select] in the [Sound]
menu to [SPEAKERS]. (see page 36)
1
9
2
-
+
ENTER
6
7
8
) (Unit)
Advertisement
Table of Contents
