Table of Contents
Advertisement
Installation, cont'd
N This port is independent of the rear panel Remote port and is not affected by
N A front panel Configuration port connection and a rear panel Remote port
N The maximum distances from the matrix switcher to the controlling device
2-12
FOX 4G Matrix Switchers • Installation
changes to the rear panel port's protocol. This front panel port's protocol can be
changed under SIS command control only. See the Command/Response table for
IP-specific SIS commands, in chapter 4, "Programmer's Guide", to configure all
ports under SIS control.
connection can both be active at the same time.
This port is RS-232 only, with its default protocols as follows:
• 9600 baud
• no parity
• 1 stop bit
• no flow control
can vary up to 200 feet (61 m). Factors such as cable gauge, baud rates,
environment, and output levels (from the switcher and the controlling device)
all affect transmission distance. Distances of about 50 feet (15 m) are typically
not a problem. In some cases the matrix switcher may be capable of serial
communications via RS-232 up to 250 feet (76 m) away.
• 8 data bits
Advertisement
Table of Contents
