Figure 3.12 Jumper Setting Of Wim; Figure 3.13 Mounting Wimd On Wim - Samsung OfficeServ 7200 Installation Manual

Hide thumbs Also See for OfficeServ 7200:
Table of Contents

Advertisement

CHAPTER 3. Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь
отображаться.
3.3.1.2 WIM
The procedure for setting the jumpers and mounting optional boards on the WIM (WAN
Interface Module) is as follows:
1) Set jumpers JP1 through JP4 of the WIM.
Managed LIM function
The Managed LIM is controlled by the WIM and provides the extension functions
related to the Layer 2 QoS management such as 802.1p (packet priority), 802.1q
(VLAN) and IGMP Snooping, etc besides Layer 2 switch functions.
To perform the Managed LIM function to manage the LIM in the WIM, the WIM
and the LIM must be mounted on slot 1 and slot 2, respectively.
2) Align the connector of the WIM to that of the WIMD and firmly press the board
downward.
3-16
JP1

Figure 3.12 Jumper Setting of WIM

Figure 3.13 Mounting WIMD on WIM

LAN port in the front
panel to connect to Ethernet
Jumper to connect to the LIM
board in slot 2 through the rear
panel (fornt socket in the WIM
board is not used at
JP4
this time.)
WIMD
© SAMSUNG Electronics Co., Ltd.

Advertisement

Table of Contents
loading

Table of Contents