Samsung OfficeServ 7200 Installation Manual page 109

8.2 Starting the System
The procedure for starting the OfficeServ 7200 is as follows:
1) Check if the boards and cables are properly mounted and connected to the OfficeServ
7200 cabinet.
2) Turn on the power of the OfficeServ 7200 basic cabinet, and turn on the power of the
expansion cabinet.
3) Check the LEDs of the MP20/MP20S and LCP.
4) The RUN LED of the MP20/MP20S lights green and the MC LED flashes when the
system normally starts the booting process.
5) Once the booting is complete, the RUN LED of the MP20/MP20S flashes green, and
the MC LED stops flashing and remains lighted.
6) The RUN LED of the LCP flashes when the power supply and processor status of the
expansion rack is normal.
If the SD card is not detected
If the system cannot detect the SD card, the MC LED of the MP20/MP20S board
might not light or flash. In such cases, turn off the power of the basic cabinet,
replace the SD card and turn the power on again. If the SD card is still not
detected, turn off the power of the basic cabinet and eject the MP20/MP20S
board.
7) Check if the LED statuses of other interface boards are normal.
8) If the LED status of a MP20/MP20S, LCP, or interface board is abnormal, turn off the
power of the cabinet and turn the power on again.
LED Status & Shut-down
- Refer to the 'OfficeServ 7200 General Description Guide' for LED statuses of
- Shut-down is hardly required while operating the OfficeServ 7200. However,
© SAMSUNG Electronics Co., Ltd.
each board.
when shutting down the system due to reasons such as moving the system,
turn off the power of the expansion cabinet, and turn off the power of the basic
cabinet.
OfficeServ 7200 Installation Manual
8-3