Configuring the network parameters using the MMC 830 program
This step configures the network parameters of the OfficeServ 7200.
Consult your network administrator for the network parameter values.
1) Set the IP address of the OfficeServ 7200.
2) Set the subnet mask of the OfficeServ 7200.
3) Set the gateway IP address of the OfficeServ 7200.
4) Reset the board.
Resetting the Board
You have the reset to board to apply the new settings. If the board is not reset
correctly, it may cause product malfunction.
Configuring the Installation Tool parameters
1) Run the Installation Tool.
2) On the main screen of the Installation Tool, select [System] [Link Control] or
click the Port Basic icon.
3) When the <Link Control> is displayed, enter the name of the system in the [Name]
field.
4) If the Link Type is LAN, enter the IP address of the OfficeServ 7200 in the
[IP Address] field.
If the Link Type is MODEM enter the internal modem number of the OfficeServ 7200 in
the [Telephone] field.
© SAMSUNG Electronics Co., Ltd.
Figure 7.25 Installation Tool
OfficeServ 7200 Installation Manual
7-21