Installing In A Rack; Cautions For Installation; Required Tools; Figure 2.1 Tools Required For Rack Installation - Samsung OfficeServ 7200 Installation Manual

CHAPTER 2. Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь
отображаться.

2.3 Installing in a Rack

This section describes how to install the OfficeServ 7200 cabinet inside a 19-inch rack.

2.3.1 Cautions for Installation

Take the following cautions when installing the OfficeServ 7200 cabinet inside a rack:

The 19-inch rack should be a standard electric equipment rack.

When using an enclosed-type rack, check if the rack is properly ventilated.
Vents should be equipped on the side of the rack and fans should be attached to
ventilate cool air into the rack.

Take special caution with an enclosed-type rack that has vents on top of the rack since
hot air coming out of the vent may enter the intake vent of a system installed above
the rack.

When using an open rack, do not block the entrance of a port or fan of the OfficeServ
7200.

2.3.2 Required Tools


A middle-sized cross screwdriver

A bracket and three screws for attaching cabinet

Two brackets and six screws for attaching rack

Two screws for fastening
2-2

Figure 2.1 Tools Required for Rack Installation

© SAMSUNG Electronics Co., Ltd.