Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Positioning the Cooker
Fig. 9.1 and Fig. 9.2 show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
Fig. 9.1 and Fig. 9.2 Cookers installed into recess: The cooker
must have side clearance ABOVE hob level of 75mm up to a
height of 410mm. This can be reduced to 25mm if the surface
is made from a non-combustible material.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for
the additional height of the flue trim, which is fitted to the
cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration.
We cannot accept responsibility for damage caused by
normal use of the cooker to any material that de-laminates
or discolours at temperatures less than 65 °C above room
temperature
DO NOT box the cooker in – it must be possible to move the
cooker in and out for cleaning and servicing.
If the cooker is near a corner of the kitchen a clearance of
130 mm is required to allow the oven doors to open (Fig. 9.3).
The actual opening of the doors is slightly less but this allows
for some protection of your hand as you open the door.
Moving the Cooker
On no account try and move the cooker while it is
n
n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n
n
We recommend that two people manoeuvre the cooker.
Make sure that the floor covering is firmly fixed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base (Fig. 9.4). Repeat from the back and remove
the rear half of the polystyrene base.
INSTALLATION
Wall
410 mm min
5 mm
25
75 mm
min
650 mm
min
ArtNo.110-0069 - 110DF - Lidded min spacings
check cookerhood instructions for actual dimensions
1102 mm
650 mm min
75 mm min
75 mm min
1092 mm
Height to Hotplate
Height to Flue Trim
905 mm min
920 mm min
930 mm max
945 mm max
ArtNo.110-0004 - 110 Cooker min spacings
130 mm min
Fig. 9.1
75 mm
min
905 mm
min
930 mm
max
Fig. 9.2
Wall
410 mm min
5 mm
Fig. 9.3
Fig. 9.4
Advertisement
Table of Contents
