Module Programming - Honeywell Fire-Lite Alarms ES-1000X Manual

Programming
1=STANDARD ADJECTIVE
2=STANDARD NOUN
3=CUSTOM ADJECTIVE
4=CUSTOM NOUN
Adjective/Noun Screen
1=BASEMENT
2=BOILER RM
3=CLASSROOM
Noun Screen #1
1=KITCHEN
2=LOBBY
3=OFFICE
Noun Screen #5
1=STANDARD ADJECTIVE
2=STANDARD NOUN
3=CUSTOM ADJECTIVE
4=CUSTOM NOUN
Adjective/Noun Screen
EDIT DETECTOR
1=ADJECTIVE/NOUN
2=DESCRIPTION
Edit Detector Screen #5
A flashing cursor will appear at the first asterisk to the left. The programmer can enter additional descriptive information about the device
being programmed. This information will appear on the display along with the standard device label information.
A maximum of 20 characters (including spaces) can be entered. To enter alphanumeric characters from the keypad, repeatedly press the
appropriate key until the desired character is displayed in the first position. For example, to enter the letter B, press the 2 (ABC) key three
times to toggle through the characters 2, A and B. Press the right arrow key to move the cursor one position to the right and repeat the process
to enter the next character. To enter a space, press the * (QZ) key four times until a blank appears in the desired position. When all characters
have been entered, press the Enter key to store the information. The display will return to the Edit Detector Screen #5, displaying the new
information at the bottom of the screen.

Module Programming

POINT PROGRAM
1=DETECTOR
2=MODULE
Point Program Screen #2

Add Module
Pressing 1 while viewing the Modules Screen will display the following screen which allows the programmer to add a new module address
to programming:
A flashing cursor will appear in the position of the first asterisk to the left. The programmer keys in the three digit module address, such as
005.
56
Pressing 2 while viewing the Adjective/Noun Screen will cause the following screen(s) to be displayed. Note
that the keypad down arrow key must be pressed to see all the Noun screens. Press the number corresponding to
the noun that is to be used as a descriptor for the location of the detector currently being programmed. When a
noun has been selected, it will appear at the top of the display as indicated by the asterisks.
1=CLOSET
2=CORRIDOR
3=ELECTRIC RM
Noun Screen #2
1=PATIENT
2=RESTROOM
3=ROOM
Noun Screen #6
Pressing 3 or 4 while viewing the Adjective/Noun Screen will display screens similar to the previous Adjective
and Noun Screens. The new screens will list custom Adjectives and Nouns which have been programmed into
the control panel using the FS-Tools utility. These descriptors are selected as described in the previous sections.
Description
The Description selection allows the programmer to enter additional information about the detector currently
being programmed. This information will be displayed as part of the device label on the display. Pressing 2
while viewing Edit Detector Screen #5 will cause the following screen to be displayed:
DESCRIPTION
ADJECTIVE/NOUN
Adjective/Noun Screen
Pressing 2, while viewing Point Program Screen #2, will allow the programmer to add, delete or change the
programming of an addressable module. The following screen will be displayed by the control panel:
1=ADD
2=DELETE
3=EDIT
ENTER MODULE#
Add Module Screen #1
1=ELEVATOR
2=ENTRANCE
3=FLOOR
Noun Screen #3
1=STAIRWAY
2=STOREROOM
3=WING
Noun Screen #7
1D002
MODULES
Modules Screen
ADD MODULE
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Master Programming Level
1=GARAGE
2=HALLWAY
3=HVAC RM
Noun Screen #4
1=ZONE
Noun Screen #8