Table of Contents
Advertisement
Chapter 3
Call Announce Intercom on
Selected Buttons
Before selecting Directory
Numbers for call screeners, you
may specify the Call Appearance
buttons that are to be answered
automatically. You may select
"ALL" buttons or select the
desired Call Appearances.
To enable or disable Call
Announce Intercom on selected
buttons, follow these steps:
1. Press REGISTER (softkey 4), 11,
ENTER (softkey 1). A screen
appears showing the current
status of the intercom feature:
INTERCOM FEATURE
NONSUPPORTED
2. Press ENTER again.
The Call Announce Intercom
button selection screen appears:
1: ALL 2: SELECT
3: NO SUPPORT
(SELECT 1-3)
3. To make your choice, dial 1 or 2
and press ENTER. If you
selected 2, the following screen
appears:
SUPPORTED (SELECT)
SELECT ASSIGN KEY
Get other manuals https://www.bkmanuals.com
( SRS -1050 Local Features
4. All LEDs will light green if "All"
was previously selected. Only
Call Appearances with lit LEDs
will activate on Call Announce.
Press the buttons to turn the
LEDs on or off to select the
desired Call Appearance
button(s).
5. Press ENTER. The following
screen appears:
SUPPORTED (SELECT/ALL)
COMPLETED
After selecting the Call
Appearance buttons that are to
be auto answered, you may
proceed to select Directory
Numbers for Call Screeners.
Specifying the Directory
Number for Intercom
When enabling the feature, you
must specify a Directory Number,
which when used by the screener
to call the recipient activates the
intercom automatically. All
recipients can specify the same
Directory Number, for all Call
Appearance Intercom calls.
Normal calls can still be made
from this Directory Number to
numbers not set up for intercom.
Up to three Directory Numbers
may be programmed.
Page 3-19
Advertisement
Table of Contents
