Switching Back To Handset-Only Operation; Changing Ringer Mode - Fujitsu SRS-1050 User Manual

Chapter 3
4. Press ENTER. This screen
appears:
SUPPORTED
COMPLETED
You can now use the speaker.
The SPEAKER button can control
call pickup or hang-up if the
handset is in its cradle. The MIC-
OFF button (if active) controls the
microphone if the speaker is in
use. If MIC-OFF is pressed, key
tones can be heard, but no other
sounds are transmitted until MIC-
OFF is pressed again.
Switching Back to Handset-
only Operation
Do steps 1 through 4 (from the
previous section), but in steps 3,
press 2 instead of 1. The final
screen will look like this instead:
NON SUPPORTED
COMPLETED
When the display shows the
selection you prefer, press REG
(softkey 4) to return to the normal
display.
Get other manuals https://www.bkmanuals.com
( SRS -1050 Local Features

CHANGING RINGER MODE

This local feature allows you to:
•
Change the volume and tone
of the ringer
•
Select the ringer mode, either
normal ring or silent ring.
Silent ring causes the LED of
the receiving Call
Appearance button to flash
green without any ringing
sound.
•
Select the ringing pattern you
will hear when you are
conversing on another line
All settings are made from item 7,
RINGER, in menu mode. After
completing a setting, you can
press asterisk (*) to return to the
menu mode options and change
another setting, or you can press
REG (softkey 4) to return to the
normal display.
Setting Ringer Volume
To set the ringer volume, follow
these steps:
1. Press REG (softkey 4), 7, ENTER
(softkey 1). This screen
appears:
RINGER SERVICE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Page 3-13