Table of Contents
Advertisement
SRS -1050 Local Features (
When specifying the Directory
Number for intercom, you must
enter all ten digits of the call
screener number. For example, for
a call screener at 926-3112, you
could enter:
919 926 3112
or
919*926*3112
Entering the full number negates
the possibility that an outside call
with the same last four digits in
the calling number (for example,
302 422-3112) could activate the
intercom.
The asterisks in the number
919*926*3112 are wild cards. The
digital set accepts any character
in this position. You need the
wild card to represent the dash (-
) if a dash is included in the
number delivered with an
incoming call. If you are in doubt,
have the person who will be
screening calls call you, and note
the number displayed on the first
line of the LCD.
The set supports up to three
numbers for screeners. To have
more than three screeners, use *
as a wild card. For example,
entering 919*926*311* allows
both the Directory Numbers 3112
and 3115 to activate the intercom.
Remember, however, that all other
Directory Numbers from 3110 to
3119 would also activate the
intercom.
Page 3-20
Get other manuals https://www.bkmanuals.com
Required Support from Your
System Administrator
To guarantee that Directory
Numbers are always available for
Call Announce Intercom, the
System Administrator should:
• Allocate one Directory Number
on the digital sets of both
recipients and screener for
outgoing calls.
Specifying the Directory
Numbers of Call Screeners
At the conclusion of selecting
buttons for Call Announce
Intercom, this screen appears:
SUPPORTED (SELECT/ALL)
COMPLETED
1. Press ENTER. If one or two way
intercom is enabled, the screen
displays the enabled mode plus
the authorized Directory
Number, as shown below:
TWO WAY TURNED ON
919*926*3112
If no telephone numbers have
been programmed in, the Call
Announce Intercom feature is
disabled, and the screen displays
NON SUPPORTED:
INTERCOM FEATURE (1)
NONSUPPORTED
Chapter 3
Advertisement
Table of Contents
