Table of Contents
Advertisement
Chapter 4
PLACING A CALL TO A LEASED NETWORK
A call to a leased network number follows the same
basic procedures given in the preceding sections,
with two differences:
•
Terminal calls can only be made using AT
commands
•
When you enter the number, you must enter a
leased network access code, including the
access code delimiter.
Using the Data Key
Before you can dial a leased network number with
the DATA key, you must assign one of your
multifunction buttons as a leased network access
code delimiter key. See Chapter 3 for the procedure.
When you enter the number of the Data Terminal
Equipment (DTE) you want to call, use one of the
following procedures:
•
Enter the telephone number of the DTE you
want to call; press the assigned leased network
access code delimiter key; then enter the leased
network access code.
•
Press the assigned leased network access code
delimiter key; enter the leased network access
code; press the delimiter key again; then enter
the telephone number of the DTE you want to
call.
Once you complete entering the leased network
number, press the SEND softkey as usual.
Using AT Commands at a Terminal
After you type ATD, type the number of the DTE
you want to call using one of these two sequences:
•
Type the telephone number of the DTE you
want to call; type a colon; then type the leased
network access code.
•
Type a colon; type the leased network access
code; type another colon; then type the
telephone number of the DTE you want to call.
Once you complete entering the leased network
number, press <CR> as usual.
( SRS -1050 Data Operation
Page 6-5
Get other manuals https://www.bkmanuals.com
Advertisement
Table of Contents
