Handsfree, Handset, And Headset Modes - Fujitsu SRS-1050 User Manual

Chapter 3
To disable unanswered call
logging, follow these steps:
1. Press REG (softkey 4), 4, ENTER
(softkey 1).
If the following screen appears,
the feature is enabled:
UNA SERVICE MODE
SUPPORTED (ALL)
To leave it as is, press REG again.
2. To disable UNA, press ENTER.
This screen appears:
1: ALL
3: NO SUPPORT SELECT ITEM
(1-3)
3. Now press 3, ENTER, and this
screen appears:
NON SUPPORTED
COMPLETED
After about 6 seconds, or if you
press asterisk (*), the display
returns to the second Service
Mode screen:
4: UNA 5: H-FREE
6: HAND/HEAD SELECT ITEM
13)
4. You can then select a different
menu function, or press REG
(softkey 4) to return to the
normal display.
Get other manuals https://www.bkmanuals.com
2: SELECT
(1-
( SRS -1050 Local Features
HANDSFREE, HANDSET, AND
HEADSET MODES
You can set up the Digital Set to
use the handset, the speaker, or a
headset by selecting from the
following modes:
Headset Mode
Enables use as a headset-only
phone. You must disconnect the
handset from the jack on the
phone's left side and plug the
headset into the same jack. Calls
are connected and disconnected
only by your pressing the
SPEAKER button. In headset
mode, the handsfree mode,
including the
speaker/microphone, is not
supported.
Handset Mode
Enables normal use as a handset
phone. While in this mode, the
speaker can be enabled or
disabled as follows:
Handsfree Supported
Allows speaker use, controlled by
SPEAKER button.
Handsfree Non Supported
Disallows speaker use. The
SPEAKER button is disabled.
Call pickup and hanging up on
calls is by handset only.
Page 3-11