Table of Contents
Advertisement
SRS -1050 Local Features (
7. Press REGISTER (softkey 4) to
return to normal operation.
Announcing a Call by
Intercom
This procedure describes a
typical sequence for announcing
a call by intercom. The procedure
addresses the call screener since
the call recipient has little to do.
The only action possibly required
of the recipient is described in
step 3.
The procedure also assumes that
both the screener and the call
recipient have an SRS-1050 digital
set, although only the recipient
must have one. If the call
screener has some other
telephone set, the exact procedure
may be different.
This procedure is by no means
the only way that you can use
Call Announce Intercom.
To announce a call by intercom,
follow these steps:
1. Press the Directory Number
designated for Call Announce
Intercom. The intercom
Directory Number indicator
lights normally.
2. Dial the extension of the call
recipient.
Page 3-22
Get other manuals https://www.bkmanuals.com
The recipient's SRS-1050 sounds
an alert tone, immediately answers
the call, and activates the
intercom feature.
3. Talk to the recipient.
If the recipient is set up for one-
way intercom, pause a few
seconds to give the recipient time
to press the MIC-OFF button and
respond. With two-way intercom,
the recipient can respond
immediately just by speaking.
Note: To transfer the call at the
same time you announce it,
use the conference call
transfer procedure.
ACTIVATING AND
DEACTIVATING THE MIC-OFF
BUTTON
The MIC-OFF button (the button
at the upper right of the
multifunction button array)
controls the microphone during
handset or handsfree operation.
With this button activated as the
MIC-0FF button, you can turn off
the microphone while on a call to
talk privately to people around
you, and then press MIC-OFF
again to continue your phone
conversation.
MIC-OFF is active by default
when your SRS-1050 is delivered.
Chapter 3
Advertisement
Table of Contents
