Soft Start/Stop Duration; Reset Cycle Count; Maintenance Alert Trigger - Linear SWR Installation Manual

Advanced Controller Programming (Cont.)

Soft Start/Stop Duration

This function is only used with DC swing gate Model SWD. This
function causes the operator to start and stop the DC motor slowly
reducing gate wear and tear (at the full open or closed positions only).
The factory default sets the Soft Start/Stop Duration to 3 seconds. The
Soft Start/Stop Duration can be set from 1 to 10 seconds.
✓ NOTE: Changing the Soft Start/Stop Duration will reset the open
and close current setting value to zero. It will be necessary to
reprogram maximum open and close current settings.
✓ NOTE: This function will only be displayed in Model SWD operators
set for DC motor operation with soft start motor selection.

Reset Cycle Count

The Controller counts of the number of times the operator has been
cycled full open and close. The cycle count can be displayed. The
display will scroll the cycle count number, flashing two digits at a time
from left to right.
To reset the Cycle Count, press and hold the ENTER button for 2 seconds
while the Cycle Count is displayed.
If the Maintenance Alert has been triggered, resetting the Cycle Count
will also reset the Maintenance Alert indicator.

Maintenance Alert Trigger

The Controller has a MAINT ALERT indicator that can be programmed
to light when the number of activations exceeds a set number of cycles.
The factory default sets the Maintenance Alert Trigger to 10,000 cycles.
The Maintenance Alert Trigger can be programmed for 5, 10, 15, or 25
thousand cycles.
The Maintenance Cycle Count can be reset independently from the
operator's absolute Cycle Count.
SWR • SWC • SWD Swing Gate Operator Installation Guide
FUNCTION
"SS"
SOFT START/STOP
DURATION
FUNCTION
PRESS ENTER TO START THE CYCLE COUNT DISPLAY
"CT"
1ST DISPLAY
NOTE: PRESS ENTER FOR 2 SECONDS
RESET CYCLE
WHILE THE "CT" FUNCTION IS DISPLAYED
COUNT
TO RESET THE CYCLE COUNT TO ZERO
FUNCTION
"MA"
PRESS UP OR
DOWN TO CYCLE
THROUGH OPTIONS
PRESS ENTER TO
SELECT AN OPTION
MAINTENANCE
ALERT TRIGGER
- 17 -
OPTIONS
SOFT START DISABLED
SET SOFT START DURATION TIME
FROM 1 TO 10 SECONDS
PRESS UP OR
DOWN TO CYCLE
THROUGH OPTIONS
PRESS ENTER TO
SELECT AN OPTION
2ND DISPLAY 3RD DISPLAY 4TH DISPLAY
EXAMPLE ABOVE SHOWS 10,420 CYCLES
DECIMAL POINT LIT
ON 4TH DISPLAY
OPTIONS
DISABLES THE MAINTENANCE ALERT
FUNCTION
SETS THIS MAINTENANCE ALERT TRIGGER
FOR 5, 10, 15, OR 25 THOUSAND CYCLES
RESETS THE MAINTENANCE ALERT
INDICATOR AND SETS THE MAINTENANCE
ALERT COUNT TO ZERO
227965 X28