Table of Contents
Advertisement
Advanced Controller Programming (Cont.)
Shadow Loop Open Prevention
If the shadow loop is triggered, it always prevents the gate from closing
if the Auto Close Timer activates or a CLOSE command is given while
the gate is at the full open position.
The controller can also be set to prevent the gate from opening if the
shadow loop is triggered while the gate is at the close limit position.
This prevents a swing gate from opening into a vehicle if it's parked
near the gate on the inside.
Low Power Mode
This function is only used with DC swing gate Model SWD. The
factory default disables the Low Power Mode. When Low Power Mode
is enabled, and AC power fails, the controller will assume Low Power
Mode after 60 seconds of gate inactivity. Low power mode turns off all
accessory power and indicators. Only inputs from the radio receiver,
reverse loop, open loop (optional by programming), fire department
input, or restoring AC power will wake the Controller from Low Power
Mode. Programming Mode can still be accessed while the Controller is
awake in Low Power Mode.
✓ NOTE: This function will only be displayed in Model SWD
operators.
Power Failure Mode
This function is only used with DC swing gate Model SWD. The
factory default is set for Fail Safe, alternately the Controller can be set
for Fail Secure, Open Immediate, or Close Immediate.
• Fail Safe: If the AC power fails and the battery voltage drops
below approximately 22 Volts, 5 seconds later the operator will
cycle open if not already open. When AC power is restored, or the
battery gets charged by solar panels, the operator will resume
normal operation and auto-close if programmed to do so.
• Fail Secure: If the AC power fails and the battery voltage drops
below approximately 22 Volts, 5 seconds later the operator will
cycle closed if not already closed. When AC power is restored, or
the battery gets charged by solar panels, the operator will resume
normal operation.
✓ NOTE: Fail Safe and Fail Secure are disabled if Stagger Mode is
enabled.
• Open Immediate: If the AC power fails, the operator will cycle
open if not already open and cease operation. When AC power
is restored, the operator will resume normal operation and auto-
close if programmed to do so.
• Close Immediate: If the AC power fails, the operator will cycle
closed if not already closed and cease operation. When AC power
is restored, the operator will resume normal operation.
✓ NOTE: This function will only be displayed in Model SWD
operators.
SWR • SWC • SWD Swing Gate Operator Installation Guide
FUNCTION
"SP"
SHADOW LOOP
OPEN PREVENTION
FUNCTION
"LP"
PRESS UP OR
DOWN TO CYCLE
THROUGH OPTIONS
PRESS ENTER TO
SELECT AN OPTION
LOW POWER
MODE
WILL ALWAYS WAKE UP CONTROLLER
FUNCTION
"FS"
PRESS UP OR
DOWN TO CYCLE
THROUGH OPTIONS
PRESS ENTER TO
SELECT AN OPTION
POWER
FAILURE MODE
- 16 -
OPTIONS
STANDARD OPERATION
SHADOW LOOP INHIBITS CLOSING ONLY
OPEN INHIBIT ON, SHADOW LOOP INHIBITS
OPENING AND CLOSING
PRESS UP OR
DOWN TO CYCLE
THROUGH OPTIONS
PRESS ENTER TO
SELECT AN OPTION
OPTIONS
LOW POWER MODE DISABLED
LOW POWER MODE #1
RADIO WILL WAKE AND ACTIVATE,
REVERSE LOOP WILL JUST WAKE
LOW POWER MODE #2 - RADIO OR
OPEN LOOP WILL WAKE AND ACTIVATE,
REVERSE LOOP WILL JUST WAKE
THE FIRE DEPARTMENT INPUT
OPTIONS
SET TO FAIL SAFE MODE
SET TO FAIL SECURE MODE
SET TO OPEN IMMEDIATE MODE
SET TO CLOSE
IMMEDIATE MODE
DC MODELS
ONLY
227965 X28
Advertisement
Table of Contents
