Kohler STERLING 6104 Series Installation And Care Manual page 21

5.
Secure the Bath
Bath Flange
Bride de la baignoire
Reborde de la bañera
Apron Flanges
Brides de bandeau
Rebordes del faldón
Screw
Vis
Tornillo
Secure the Apron
Drill one 1/8" (3 mm) pilot hole through each apron flange and into a stud. Fasten
the flanges to the studs using non-tapered flathead screws.
NOTE: If the apron flanges have broken off from the apron, ensure that the apron is
held in place by the wooden blocks (previously installed). If a baseboard will be
installed at the apron, drill pilot holes and fasten the apron to the wooden blocks.
Attach the Bath to the Studs
NOTE: The bath can be attached using the clips (provided) or non-tapered flathead
screws. Ensure the non-tapered flathead screws are galvanized or plated.
Verify the studs are within 1/8" (3 mm) of the bath at the recommended clip or
screw locations. Shim if necessary.
For clip attachment (1):
Refer to the "Roughing-In" section for recommended clip locations.
At the side of the stud, position the bottom lip of the clip under the flange of the
bath, as shown.
Slide the clip into place between the center of the stud and the bath.
Use a pliers to bend the tab of the clip over the bath flange.
Repeat these steps for the remaining clips.
Secure the clips to the studs with non-tapered flathead screws.
Sterling
(1)
Stud/Montant/Poste de madera
Screw
Vis
Tornillo
Attachment Clip
Clip d'attache
Clip de sujeción
Bath/Baignoire/Bañera
(2)
Stud
Montant mural
Poste de madera
21 1064909-2-B