Table of Contents
Advertisement
Ajuste inicial de las paredes circundantes (cont.)
Verifique que todas las paredes estén bien alineadas con los postes de madera en
los rebordes superior y vertical de las paredes. Si es necesario, añada cuñas para
poner los postes de madera en contacto con las paredes.
7.
Prepare the Wall Surrounds
1
2
Mark center of valves and
Drill pilot holes on back of wall.
spout.
Percer les trous-pilotes sur le
Marquer le centre des
mur arrière.
valves et du bec.
Taladre los orificios guía en la
Marque el centro de las
pared posterior.
válvulas y del surtidor.
For Baths with Wall Surrounds Only
Prepare the Plumbing End Wall
NOTE: Holes for the mixing valve, shower, and spout must be cut into the plumbing
end wall.
Refer to the trim manufacturer's instructions for necessary hole sizes. Verify that
any escutcheon, flange, or cover plate is large enough to cover the hole for the
component.
Lay out and mark the centerline location for the mixing valve, shower, and spout
on the back side of the end wall. (1)
Drill 1/4" (6 mm) pilot holes at the marked locations from the back side of the
end wall. (2)
CAUTION: Risk of product damage. Failure to follow directions regarding your
blade's cutting direction may damage the plumbing end wall finish. Cut the holes
from the front side of the wall for: hole saws, rotary tools, hand-held jigsaws, or
other saws with a blade that cuts on the push stroke. Cut the holes from the back
side of the wall for other reciprocating saws with a blade that cuts on the pull
stroke.
Carefully cut the fitting holes to the correct diameter. (3) Refer to the trim
manufacturer's instructions for proper diameter.
Carefully clean any debris from the bath to reduce the risk of surface damage.
Optional Accessories
NOTICE: Do not install accessories that require backing or support. Installations that
require drilling into the wall surrounds are not recommended. Such installation could
void the warranty.
Refer to the accessory manufacturer's instructions for proper installation.
If drilling is required, mark and drill the mounting locations for your accessory on
the back side of the wall. Do not secure the accessory at this time.
1064909-2-B
3
Cut holes through front of wall.
Découper les orifices dans le
mur.
Perfore los orificios a través del
frente de la pared.
26
Sterling
Advertisement
Table of Contents
