Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Final Fitting
Fitting the Handles and Handrail
Remove the 4 mm Allen screws from the doors (Fig. 9.15). Fit
the door handles and secure using the 4 mm screws.
The handles should be above the fixings.
n
n
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 9.16). Fit the front handrail in position and secure
using the 4 mm screws.
Fitting the 2-piece Plinth
Fit the inner plinth to the bottom front of the cooker using
the 4 or 5 screws provided (Fig. 9.17).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 9.18).
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Final Checks
Hotplate Check
Check each burner in turn (refer to the 'Hotplate Burners'
section at the front of the instructions).
Grill Check
Turn on the grill and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the that the oven burners light
and start to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn off the ovens.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
INSTALLATION
ArtNo.215-0026 - Handle gaskets fixed
Art No 215-0028 - Handrail fascia fixings
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Inner plinth
27
Outer plinth
Outer plinth xing screw
Fig. 9.15
Fig. 9.16
Fig. 9.17
Fig. 9.18
Advertisement
Table of Contents
