Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Fig. 10.15
ArtNo.215-0026 - Handle gaskets fixed
Fig. 10.16
Art No 215-0028 - Handrail fascia fixings
Fig. 10.17
ArtNo.350-0012 - Securing the plinth
Fig. 10.18
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Fig. 10.19
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth xing screw
Inner plinth
INSTALLATION
Final Fitting
Fitting the Handles and Handrail (Classic Deluxe)
Remove the 4 mm Allen screws from the doors (Fig. 10.15).
Fit the door handles and secure using the 4 mm screws.
The handles should be above the fixings.
n
n
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 10.16). Fit the front handrail in position and
secure using the 4 mm screws.
Fitting the 1-piece Plinth (Professional +)
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig. 10.17).
Fitting the 2-piece Plinth (Classic and Kitchener)
Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 10.18).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 10.19).
Fitting the Splashback (Classic)
The cooker can be installed with or without the supplied
splashback.
To fit the splashback, first remove the two 3 mm fixing screws
and nuts on the rear of the grill flue. Hold the splashback in
position and refit the screws and nuts to secure.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Outer plinth
36
Advertisement
Table of Contents
