Final Checks; Final Fitting; Customer Care - Rangemaster Classic 110 Gas User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Fig.7.13
ArtNo.215-0026 - Handle gaskets fixed
Fig.7.14
Art No 215-0028 - Handrail fascia fixings
Fig.7.15
ArtNo.350-0012 - Securing the plinth
INSTALLATION

Final Checks

Hotplate Check
Check each burner in turn (refer to the 'Hotplate Burners'
section at the front of the instructions).
Grill Check
Turn on the grill and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the oven burners light and start
to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn off the ovens.

Final Fitting

Fitting the Handles and Handrail
Remove the 4 mm Allen screws from the doors (
the door handles and secure using the 4 mm screws.
The handles should be above the fixings.
n n
Remove the 4 mm Allen screws from the top corners of the
fascia ( ). Fit the front handrail in position and secure
Fig.7.14
using the 4 mm screws.
Fitting the Plinth
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.

Customer Care

Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
28
).
Fig.7.15
(Classic only)
(Classic only)
). Fit
Fig.7.13