Electrical Connection; Final Checks; Final Fitting; Fitting The Plinth - Rangemaster Classic Deluxe 110 User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
See the data badge for test pressures.
Turn off the burners. Make sure that you reassemble the
burner top in the correct way on the burner body.

Electrical Connection

The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
n n
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double-pole
switch, having a contact separation of at least 3 mm in all
poles.
The cooker MUST NOT be connected to an ordinary
n n
domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (Fig. 8.15 and Fig. 8.16). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.

Final Checks

Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier, and then turn on the ovens.
Check the oven fan start to turn and that the ovens heat up.

Final Fitting

Fitting the Plinth

Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 8.17). Fit the outer plinth (2
screws, 1 each end) to the inner plinth. The height of the
outer plinth can be adjusted by sliding it up or down via the
slotted hole (Fig. 8.18).
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.

Customer Care

Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
(optional)
INSTALLATION
Current Operated Earth Leakage Breakers
The combined use of your induction cooker and other
domestic appliances may cause nuisance tripping, so we
recommend that the cooker is protected on an individual
RCD (Residual Current Device) or RCBO (Residual Current
IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIED
L
N
10 mm² max
ArtNo.130-0010 Electrical connections single-phase
230 V ac 50 Hz
L1
N
L3
L2
6 mm² max
3N ac
230/400 V 50 Hz
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Inner plinth
31
Breaker with Overload).
ELECTRICIAN.
Outer plinth xing screw
Fig. 8.15
6 mm² max
Fig. 8.16
6 mm² max
10 mm² max
Fig. 8.17
Fig. 8.18
Outer plinth