Heat & Glo 6000CL-IFTLP-S Installation Manual page 65

Log Set Assembly: LOGS-8CL
Models: 8000CL-IPI-S, 8000CL-IPILP-S, 8000CL-IPI-T, 8000CL-IPILP-T
8000CL-IFT-S, 8000CL-IFTLP-S, 8000CL-IFT-G, 8000CL-IFTLP-G
FIBER BURNER TOP
BURNER SHIELD
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 1
CAUTION: Logs are fragile, handle with care. Log #1 (SRV2168-701): Locate log placement tabs on the pilot cover. Bend
tabs upward as shown in Figure 2. Locate the log placements slots on the bottom of Log # 1 (see Figure 3). Mate the slots
located on the bottom of Log #1 with the log placement tabs on the pilot cover. Log # 1 is properly installed when it sits
squarely and completely on pilot cover with tabs engaged. See Figure 4.
LOG PLACEMENT SLOTS LOG PLACEMENT SLOTS
Figure 3
Figure 4 shows the log placement tabs located on the top of Log # 1. The tabs will be mated with the slots located on the
bottom of Log #2 and Log #3 (see Figure 5). Log #2 and Log #3 also have grooves that allow the logs to be seated properly
on the grate (see Figure 5). Hold Log #1 upright while placing Log #2.
Bottom view of Bottom view of
Logs # 2 and 3 Logs # 2 and 3
3 3
Figure 5
Log #2 (SRV2168-702): Mate the slot located on the bottom of Log #2 with the left log placement tab on top of Log #1.
After slot and tab have been fitted together, mate the groove located on the bottom of Log #2 with the horizontal grate bar
and slide Log # 2 toward the left until it rests against the far left grate tine.
LOCATING HOLES
TAB BENT IN = NG
PILOT COVER
TAB NOT BENT = LP
SLOTS SLOTS
2 2
GROOVES GROOVES
Heat & Glo • 6000CL-IFT, 8000CL-IFT Installation Manual • 2504-980 Rev. Q • 11/21
LOG PLACEMENT INSTRUCTIONS
LOG PLACEMENT INDENTATIONS LOG PLACEMENT INDENTATIONS
LOG PLACEMENT TABS LOG PLACEMENT TABS
Figure 2. Firebox Shown with Optional Refractory
LOG PLACEMENT TABS LOG PLACEMENT TABS
Figure 4
LEFT GRATE TINE LEFT GRATE TINE
2 2
Figure 6
GRATE TINE GRATE TINE
1 1
1 1
65