Heat & Glo 6000CL-IFTLP-S Installation Manual page 66

2 2
HORIZONTAL GRATE BAR HORIZONTAL GRATE BAR
Figure 7
Log #3 (SRV2168-703): Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1.
After slot and tab have been fitted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar
and far right grate tine. Log #3 will sit down on top of both the grate tine and the horizontal grate bar (see Figure 7.)
Log #4 (SRV2168-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right to
left under Log #2 to fit completely and securely into the indentation (see Figure 8). The back or Log # 4 should rest against
the far left grate tine as well as contact Log # 2.
FLAT AREA FLAT AREA
2 2
4 4
Figure 9
Log #5 (SRV2168-705): Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log fits
completely and securely in the indentation (see Figure 9). Log #5 should be pulled to the left hand side of log indentation.
Log #6 (SRV2168-706): Mate the groove located on the lower end of Log #6 with the fourth tine (from left to right) as shown
in Figure 10. Set the other end of Log #6 on the flat area located on top of Log #4 (see Figure 9). Log #6 will also rest against
center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing movement or shifting.
2 2
4 4
Figure 11
66
RIGHT GRATE TINE RIGHT GRATE TINE
1 1
3 3
1 1
3 3
5 5
RAISED KNOT RAISED KNOT
1 1
3 3
6 6
7 7
5 5
Heat & Glo • 6000CL-IFT, 8000CL-IFT Installation Manual • 2504-980 Rev. Q • 11/21
2 2
4 4
LOG #4 CONTACTS LOG #2 LOG #4 CONTACTS LOG #2
Figure 8
LOG #6 CONTACTS TOP OF LOG #4 LOG #6 CONTACTS TOP OF LOG #4
2 2
4 4
Figure 10
LOG CONTACTS GRATE TINES LOG CONTACTS GRATE TINES
Log #7 (SRV2165-707): Place back (unnotched) end of Log
#7 on the flat area on the top of Log #5. Log #7 must be
pulled tight to the locating notch. Pivot the front (notched)
end of Log #7 to the right until the notch of Log #7 contacts
the grate tine located 4th from the left as shown in Figure 11.
1 1
FLAT AREA FLAT AREA
LOCATING LOCATING
1 1
NOTCH NOTCH
6 6
5 5
3 3
3 3