Table of Contents
Advertisement
C. Decorative Fronts
Only decorative fronts certified for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and finishing material
is going to be used on the fireplace, you may use the
table below which shows the decorative front models and
the finishing material thickness allowed.
Note: Finishing strips may be used to aid in position-
ing of non-combustible facing materials for some of the
facing and decorative front combinations specified in
the table above. They must be removed following fin-
ishing work. See Figure 10.9.
DECORATIVE
FIT
FRONT
Folio
Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Chateau Forge
Inside
Overlap
Galleria
Inside
CF
Inside
Overlap
Iron Age
Inside
FINISH MATERIAL
SEE
THICKNESS
FIGURE
0-6 inches max.
10.8
1 inch or less
10.6
1-6 inches max.
10.7
1 inch or less
10.6
1-6 inches max.
10.7
1 inch or less
10.6
1-6 inches max.
10.7
1 inch or less
10.6
1-6 inches max.
10.7
1 inch or less
10.6
1-6 inches max.
10.7
0-6 inches max.
10.8
1 inch or less
10.6
1-6 inches max.
10.7
Heat & Glo • 6000CL-IFT, 8000CL-IFT Installation Manual • 2504-980 Rev. Q • 11/21
Finishing Material:
1 Inch Thick or Less
Remove Finishing Strips. See Figure 10.9.
NOTICE: Remove finishing strips before firing appliance.
DOOR
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
FINISHING STRIPS NOT USED
Figure 10.6 Finishing Material 1 Inch Thick or Less
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
(See Figure 10.9 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL
55
Advertisement
Table of Contents
