Appliance Setup; Remove The Shipping Materials; Clean The Appliance; Install The Glass Refractory (Optional) - Heat & Glo COSMO32-IFT-B Installation Manual

11 11

Appliance Setup

A. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before fi nishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative barrier front of the ap-
pliance, depending on the fi replace model. Splatter
guards must be removed before appliance is fi red.
• The left and right side non-combustible boards are
packaged within the splatter guard. Remove them
by carefully disengaging the tabs from the slots on
the lower portion of the splatter guard. Install as
instructed in Section 6.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Install the Glass Refractory (Optional)
An optional glass refractory kit is available for use with the
COSMO32-IFT-B, COSMO36-IFT-B and
IFT-B models. Install the glass refractory per instructions
included with the kit.
D. Install LED Lights (Optional)
An optional LED light kit is available for use with the
COSMO42-IFT-B, COSMO36-IFT-B and COSMO32-
IFT-B models. Install the LED lights per the instructions
included in the kit.
E. Install Stones (Optional)
An optional stones kit is available for use with the COS-
MO42-IFT-B, COSMO36-IFT-B and COSMO32-IFT-B
models. Install the stones per instructions included with the
kit.
F. Install Log Sets (Optional)
Optional log sets are available for use with the COSMO42-
IFT-B, COSMO36-IFT-B and COSMO32-IFT-B models.
Install the log set per instructions included with the kit.
Heat & Glo • COSMO32-IFT-B, COSMO36-IFT-B, COSMO42-IFT-B Installation Manual • 2619-980 Rev. G • 7/20
68
G. Install Media
Decorative glass media is included with the COSMO42-
IFT-B, COSMO36-IFT-B and COSMO32-IFT-B models.
COSMO42-
Placing the Media
Install glass media around the burner ensuring that no
media is placed on the burner or in the gap located be-
hind the burner. See Figure 11.1. Install media on top of
pilot shield.
NO MEDIA ON BURNER NO MEDIA ON BURNER
Figure 11.1 Media Placement
WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in area in front of pilot
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the Hearth
& Home Technologies-supplied options for this
fi replace model.
Fireplace will not function properly.
Delayed ignition may occur.
WARNING
Risk of Asphyxiation or Fumes.
• Place media according to instructions.
• Do NOT place media in area between glass and
fi rebox.
• Do NOT place media in a position that they may
fall into area between glass and fi rebox.
• Do NOT use any media other than the media
supplied with this fi replace.
Fireplace will not function properly.
Gas leak may occur.
NO MEDIA IN GAP NO MEDIA IN GAP
PILOT SHIELD PILOT SHIELD