Table of Contents
Advertisement
6
Appliance Preparation
A. Vent Collar Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
Top Vent
Figure 6.1 For top vent, remove the screw holding the
elbow heat shield in place.
2 SCREWS
Figure 6.2 For top vent, remove the two screws holding the
top heat shield in place.
Hearth & Home Technologies • DV3732-B, DV3732L-B, DV4236-B Installation Manual • 2496-980 Rev. M • 10/19
WARNING! Risk of Fire! Do not remove heat shield. El-
evated header temperatures may cause a fire.
Figure 6.3 Rotate the top heat shield to the vertical
position as shown above. The heat shield must remain in
the vertical position.
2 SCREWS
Figure 6.4 Replace the two screws as shown.
Note: Actual unit may look different than the fireplace shown
in this section.
Figure 6.5 Remove the seal cap.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
37
Advertisement
Table of Contents
