Table of Contents
Advertisement
7
Appliance Preparation
A. Top Vent
Remove the cover plate by removing the four
Figure 7.1
screws holding it to the top of the appliance. Remove
and discard the cover plate.
Remove the center insulation plug.
Figure 7.2
Cut the metal retaining band and fold the
Figure 7.3
sides out.
Hearth & Home Technologies • BE-32 • InD • 2099-985 Rev. C • 9/06
Fold the center parts of the retaining band up
Figure 7.4
and use to remove the vent cap.
Discard the vent cap, remove and discard
Figure 7.5
the insulation basket. Note: Once the vent cap has been
removed it CANNOT be reattached.
Proceed to Section 7. C.
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses dur-
ing installation.
23
Advertisement
Table of Contents
