Omron F3SJ-A P 01TS Series User Manual page 143

Control unit
Appearance
Spatter Protection Cover (2 cables per set, one for emitter and one for receiver)
Appearance
Protect bar (2 sets, common for emitter/receiver)
Appearance
Protection bracket for protect bar (4)
Appearance
Model name Output
G9SX-AD322-T15 Solid-state output
(Instantaneous
output X 3, OFF-
delay output X 2)
Model name
F39-HJ In this table, the  in the model indicates the same 4-digit
number as the protective height ( in the model) of the
F3SJ.When a spatter-proof cover is attached, operating range of
F3SJ is reduced by about 10%.Spatter-proof cover with 1970 or
higher of  in the model is divided into 2 in combination to
use.
Model name
F39-PJ Two protect bars are provided in a set (common for
emitter/receiver). For side mounting of F3SJ with a width
of 1001mm or wider, you must purchase protection
bracket (4) for protect bar (F39-PJ-MS).
Model name
F39-PJ-MS Intermediate mounting bracket for side mounting using a
protect bar. You must purchase 1 set for one protect bar
with F3SJ protective height from 1001 to 2000mm, or 2
sets for one protect with the protective height of 2009 to
2500mm.
Appendix
Note
- F39-JDA cable with connector on one
end is required.
- F3SJ with PNP output can be connected.
- OFF-delay within 15 seconds can be set to
16 levels.
- Use as instantaneous output is possible by
setting OFF-delay output to 0 seconds.
- Can be configured for partial control and
total control.
- Relay unit can also be connected.
Note
Note
Note
User's Manual
E
F3SJ-A
125