Omron F3SJ-A P 01TS Series User Manual page 135

Emitter Receiver Error code
5B, 5E
C
C
B
B
A
A
5D
C C
B
B
A
A
60, 61, 62,
63, 64, 65
C
C
B B
A
A
Error Description
Incorrect wiring of The reset input line is not properly
reset input line/ wired.
white wire on the
Emitter side white line is short-
emitter side
circuited to 24V
Connection positions are reversed
for emitter(s) and receiver(s).
Connection direction is upside
down for emitter(s).
Emitter(s) and receiver(s) are
reversely connected when
connected to connector type
controller.
(Connectors of F3SP-B1P's
emitter/receiver are reversely
attached, etc.)
A contact failure due to the loose
connector, the intrusion of liquid
(oil etc.) into the connector, or the
attachment of a foreign material
has occurred.
After eliminating the cause of the problem, power cycle the F3SJ.
Muting wiring The reset input line is not properly
error wired when muting enabling
keycap is attached.
After eliminating the cause of the problem, power cycle the F3SJ.
Safety output Safety output lines are short-
error (1) circuited to each other at power
on.
Safety output line and 24V, 0V, or
other input/output line are short-
circuited at power on.
Temporary power supply voltage
reduction in motion.
Cause
Check wiring of reset input line
and emitter side white line.
p.17
Correct connection positions and
directions of all F3SJs.
p.57
Check connectors' positions.
After cleaning the inside of the
connector (if any foreign material
is attached), tighten the connector
more closely.
Wire the reset input line properly.
p.28
Wire the output lines properly.
Check the control output is in
contact with other lines at the
device or the connection.
Check for temporary power
supply voltage reduction (by about
12VDC) by the influence of the
induction load etc. If the exclusive
power supply is not used, check
the power consumption of other
connected devices for enough
capacity.
Appendix
Solution
F3SJ-A
117
User's Manual
E