Siemens SIPROCESS GA700 Compact Operating Instructions page 47

1. Prepare the Ethernet cable:
Figure 4-2
– Isolate the Ethernet cable
– Insert the Ethernet cable through the cable gland. Make sure that the exposed shielding
– Screw the cable gland closed.
2. Fasten the prepared gland at the device:
Figure 4-3
– Fasten the Ethernet cable in the cable gland
Connecting the Ethernet cable
1. Strip the free cable end.
2. Assemble the stripped cores in a FastConnect plug.
3. Insert the Ethernet plug into the ethernet interface of the processing unit. You must feel for
the position of the interface.
SIPROCESS GA700 rack and wall mounted devices
Compact Operating Instructions, 06/2023, A5E35134047-AB
①
Cable gland
②④
Contact shielding
③
Ethernet cable
⑤
Shielding braid
Ethernet cable shielding
a length of approx. 1 cm.
braid rests on the shield contact
⑥
Plate with cable glands
⑦
Position cable gland Ethernet cable (underside of the device)
Ethernet cable: Position of the cable gland
③
at the desired location so that the braid
② ④
or .
⑦
at the plate
Connecting
4.5 Electrical connections
⑤
is exposed over
⑥
.
47