Electrical Connections; Connection Information; Requirements For Electrical Connection - Siemens SIPROCESS GA700 Compact Operating Instructions

4.5

Electrical connections

4.5.1

Connection information

Danger due to electrical current
The power cable to be connected at the customer location could be damaged by improper
connection to the device.
• Check whether the existing line voltage corresponds to the line voltage specified on the
• Before starting up the device, you should carry out a visual inspection and PE conductor test
• Because part of the cable runs in the device, always adhere to the product safety standard
Note
Insulation of external connections
The insulation of the external connections against the power inlet for proper operation of the
device with a rated voltage up to 300 V is designed for 3000 V AC.
Note
Connection requirements
The power cable must comply with the valid regulations and conditions for the place of
installation and be provided with a protective conductor at the potential of the enclosure. The
cross-section of each wire must be ≥1 mm
4.5.2

Requirements for electrical connection

• Ensure that a power disconnection unit belonging to the device is located in the direct vicinity
of the device.
This power disconnection device must be labelled so that it is linked exclusively with this
device.
• Check that the existing power supply corresponds to that specified on the rating plate of the
device.
SIPROCESS GA700 rack and wall mounted devices
Compact Operating Instructions, 06/2023, A5E35134047-AB
WARNING
nameplate of the device or in the technical specifications.
You can also find the required line voltage in the test certificate valid for your country.
of the cable. To do this, proceed in accordance with the country-specific safety standards,
regulations or other applicable directives.
IEC/EN 61010-1 or its national equivalent.
(17 AWG).
2
Connecting
4.5 Electrical connections
45