Fujitsu AIRSTAGE J-II Design & Technical Manual page 617

SET3 setting
z „
● Wireless remote controller custom code switch
This DIP switch sets the custom code of the wireless remote controller of an indoor unit.
If multiple indoor units are being installed in the same room, switch the custom codes of the
corresponding wireless remote controllers in order to prevent their signals from being mixed.
When switching the custom code of the wireless remote controller of an indoor unit, be sure to
also switch the code setting on the paired wireless remote controller side at the same time.
SET3-1 SET3-2
OFF OFF
u
ON OFF
OFF ON
ON ON
How to switch the code on the wireless remote controller side
1
3
2
● SET3-3, SET3-4 setting prohibited
SET3-3 SET3-4
OFF OFF
u
ON ON
(u...Factory setting)
Custom code
Type A
Type B
Type C
Type D
1) Press the MODE button for more than five seconds to
start the code change.
2) Press the SET TEMP. (p) or (q) button to select the
desired code.
A B C
   
3) Press the MODE button again to end the code change.
(u...Factory setting)
Fixed at OFF
Setting prohibited
- (07-91) -
D