Fujitsu AIRSTAGE J-II Design & Technical Manual page 568

ADDRESS SETTING
„ „
Indoor unit address setting
z „
6) Pressing the "+" or "-" button, select a remote controller address (select the indoor unit you
want to operate). Then press the "ENTER" button.
7) Pressing the "+" or "-" button, display function number 01. Then press the "ENTER" button.
8) Pressing the "+" or "-" button, set up the indoor unit address. (The setting range is from 00
to 63.)
● When indoor unit address data was not set
up on the indoor unit (-- is displayed.)
● Set up indoor unit address data again.
9) Pressing the "ENTER" button to return to the address selection screen. If setting has been
completed, pressing the "MENU" button to return to the Menu 2 item selection screen.
Ex.) When remote controller address "01" is selected
ERROR
●
- (07-42) -
Remote controller address
Function number
Indoor unit address
Ex.) When indoor unit address
data "12" is set up
GOOD
When indoor unit address data was normally
set up on the indoor unit.