Garmin GNS 530 Pilot's Manual And Reference page 66

SECTION 4
DIRECT-TO NAVIGATION
Cancelling Direct-to Navigation
navigation guidance to the selected destination until the
direct-to is replaced with a new direct-to or flight plan,
cancelled, or the unit is turned off.
Cancelling a direct-to:
1) Press the Direct-to Key to display the Select
Direct-to Waypoint Page.
Press the MENU Key to display the Direct-to
2)
Page Menu (Figure 4-13).
Figure 4-13 Select Direct-to Page Menu
3) With 'Cancel Direct-to NAV?' highlighted, press
the ENT Key. If a flight plan is still active, the
GNS 530 resumes navigating the flight plan
along the closest leg.
Specifying a Course to a Waypoint
great circle course to the selected destination. The course
to the destination can also be manually defined using the
Manually defining the direct-to course:
1) Press the Direct-to Key.
2) Use the small and large right knobs to select
the destination waypoint.
4-6
3)
4)
5)
6)
GNS 530(A) Pilot's Guide and Reference
Press the ENT Key to confirm the selected
waypoint, then turn the large right knob
to highlight the course ('CRS') field (Figure
4-14).
Figure 4-14 CRS (Course) Field Highlighted
Turn the small and large right knobs to select
the desired course (Figure 4-15) and press the
ENT Key.
Figure 4-15 Course Field Selected
Press the ENT Key again to begin navigation
using the selected destination and course.
To re-select a direct course from present
position (or select a new manually-defined
course), simply press the Direct-to Key,
followed by the ENT Key twice.
190-00181-00 Rev. G