Garmin GNS 530 Pilot's Manual And Reference page 226

SECTION 14
ADDITIONAL FEATURES
Highlighting TIS Traffic Using Map Page
Panning
pilot to move the map beyond its current limits without
select the panning function, a target pointer flashes on the
display showing the latitude/longitude position of the
pointer, plus the bearing and distance to the pointer from
the present position.
Activating the panning feature and panning
the map display:
1) Press the small right knob to activate the
panning target pointer.
2) Turn the small right knob to move up (turn
clockwise) or down (counterclockwise).
3) Turn the large right knob to move right (turn
clockwise) or left (counterclockwise).
4) To cancel the panning function and return to
the present position, press the small right
knob.
Traffic Range
and Altitude
Separation
Target
Pointer
Figure 14-18 Traffic Range and Altitude Separation
14-10
Power-Up Test
The TIS interface performs an automatic test during
power-up.
right knob to
Message
FAILED
DATA FAIL
NO DATA
GNS 530(A) Pilot's Guide and Reference
If the system passes the power-up test, the
If the system passes the power-up test and the
configuration at the time of installation, see the
If the system fails the power-up test, one of the
Description
GTX 330 has failed
Data is being received from the GTX 330,
but a failure was detected in the data stream
Data is not being received from the GTX 330
Table 14-2 Power-up Messages
NOTE: 'NO DATA' may be a normal mode of
operation in a dual transponder installation
where the GTX 330 with TIS is not the selected
transponder.
190-00181-00 Rev. G