Garmin GNS 530 Pilot's Manual And Reference page 32

SECTION 2
COM
NOTE: The tuning cursor normally appears in the
COM Window, unless placed in the VLOC Window
by pressing the small left knob. When the tuning
cursor is in the VLOC Window, it automatically
returns to the COM Window after 30 seconds of
inactivity.
Selecting a COM frequency:
1) If the tuning cursor is not currently in the COM
Window, press the small left knob momentarily
(Figure 2-3).
Figure 2-3 Standby Frequency of 135.325
Turn the large left knob to select the desired
2)
megahertz (MHz) value. For example, the '135'
portion of the frequency '135.325'.
3) Turn the small left knob to select the desired
kilohertz (kHz) value. For example, the '.325'
portion of the frequency '135.325'.
NOTE: The active frequency in either window
cannot be accessed directly, only the standby
frequency is highlighted by the tuning cursor.
2-2
4)
The tuning cursor is normally in the
left knob momentarily to place the cursor in the
GNS 530(A) Pilot's Guide and Reference
To make the standby frequency the active
frequency, press the COM Flip-flop Key
(Figure 2-4).
Figure 2-4 Active Frequency of 135.325
frequency, press the small
190-00181-00 Rev. G