Garmin GNS 530 Pilot's Manual And Reference page 25

IFR Procedures
approaches are stored within the
available using the PROC
To display the
PROC Key.
Figure 1-23 Procedures Page
The steps required to select and activate an approach,
departure, or arrival are identical. This introductory
approach, but keep in mind the same process also applies
to departures and arrivals.
Selecting an approach, departure, or
arrival:
1) Turn the large right knob to select the desired
option ('Select Approach?', 'Select Arrival?',
or 'Select Departure?') from the Procedures
Page.
Press the ENT Key to display a list of
2)
available procedures for the arrival (when using
approaches or STARs) or departure (when using
SIDs) airport.
Turn the small right knob to select the desired
3)
procedure and press the ENT Key.
190-00181-00 Rev. G
4)
5)
In the flight plan or direct-to, the departure or arrival
airport is replaced with the sequence of waypoints
contained within the selected procedure.
GNS 530(A) Pilot's Guide and Reference
INTRODUCTION
For approaches, a window appears (Figure
1-24) to select the desired initial approach
fix (IAF) or provide a 'vectors' option to select
just the final course segment of the approach.
Turn the small right knob to select the desired
option and press the ENT Key. (The 'vectors'
option extends the final inbound course beyond
the final approach fix, allowing the pilot to
intercept the final course segment beyond its
normal limits.)
Figure 1-24 Approach Window
For departures and arrivals, a window appears
to select the desired transition. Turn the small
right knob to select the desired option and
press the ENT Key.
SECTION 1
1-15