Completing The Installation Checklist - Eaton 93E MK2 Installation And Operation Manual

Installation Checklist

All packing materials and restraints have been removed from each cabinet.
 
The
UPS cabinet is placed in its installed location. Refrain from installing UPS direct under Air con duct.
 
All conduits and cables are properly routed to the UPS and any ancillary cabinets.
 
All power cables are properly sized and terminated.
 
Neutral conductors are installed.
 
A ground conductor is properly installed.
 
Building alarms are wired appropriately. (Optional)
 
LAN drops are installed. (Optional)
 
LAN connections have been completed. (Optional)
 
The REPO device is mounted in its installed location and its wiring is terminated inside the UPS
cabinet. (Optional)
 
A jumper wire is connected between pins 3 and 4 on the REPO terminal block if using a normally-
closed REPO switch. (Optional)
 
All terminal cover plates are installed.
 
Accessories are mounted in installed locations and wiring is terminated inside the UPS cabinet.
(Optional)
 
Air conditioning equipment is installed and operating correctly.
  
The area around the installed UPS system is clean and dust-free. (Eaton recommends that the UPS
be installed on a level floor suitable for computer or electronic equipment.)
 
Adequate workspace exists around the UPS and other cabinets.
 
Adequate lighting is provided around all UPS equipment.
 
A 230 Vac service outlet is located within 7 .5 meters (25 feet) of the UPS equipment.
 
Startup and operational checks are performed by an authorized Eaton Customer Service Engineer,
parallel systems or installations with accessory cabinets.
Parallel System Installation Checklist

Each cabinet in the parallel system is placed in its installed location. Refrain from installing UPS direct
under Air con duct.
 
All conduits and cables are properly routed to the UPSs and to the parallel tie cabinet.
 
All power cables are properly sized and terminated.
 
Neutral conductors are installed between cabinets as required.
 
Ground conductors are properly installed.
 
CAN wiring between the UPSs is properly installed.
 
Pull chain wiring between the UPSs is properly installed.
 
Adequate workspace exists around the UPSs, parallel tie cabinet, and other cabinets.
 
Startup and operational checks are performed by an authorized Eaton Customer Service Engineer, for
parallel systems.
38 Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation
for