Table of Contents
Advertisement
H2 NIR Upgrade Installation Guide
Install NIR Upgrade for Classic
5. Use a flathead screwdriver to remove the test
chamber slide gate limit switch sensor from the air
cylinder. Let it hang. Keep track of the screw.
Remove the test chamber
slide gate limit switch sensor.
6. Disconnect the moisture sensor.
a. Unplug the moisture cable from the moisture port
of the DSP module.
b. Remove the zip ties that secure the moisture
sensor cable to the chassis.
c. Reapply three zip ties to secure the load B cable to
the chassis. Trim the zip tie tails.
20
Advertisement
Table of Contents
