H2 NIR Upgrade Installation Guide
Your H3 installation is complete. You are ready to follow standard harvest procedures.
Install NIR Upgrade for Single, Twin, and Triple
5. Open Diagnostics, and tap the Sensor Info tab. Check
the following settings.
■ Detected sensor type: SCiO.
■ SCiO code version: If unsure if this is latest version
check with HarvestMaster repsentative.
■ SCiO connected: Yes.
6. Calibrate the test weight load cell, weigh bucket load
cells, and slope and motion. (See the Mirus manual for
how to calibrate.)
7. Ensure that the air lines were connected properly.
a. Open Diagnostics.
b. Open and close each gate while watching the
GrainGage to verify that the gates open and close
as expected.
17