Master Effects [Master Comp/Eq] - Roland V-Drums TD-20 Owner's Manual

LO-FI
Intentionally degrades the sound quality for creative
purposes.
Parameter Value
Fs Rate OFF, 1/2–1/32
Bit OFF, 15–1
BPF Cutoff 0–100
BPF Mix 0–127
RING MOD
Applies amplitude modulation (AM) to the input signal,
producing bell-like sounds.
Parameter Value
Freq 0–127
Master Effects [MASTER
COMP/EQ]
A stereo compressor (limiter)/three-band equalizer provides
final audio touches to the total sound of the TD-20. Can be
used for each kit and/or all kits.
fig.04-007_70
1. Press [MASTER COMP/EQ].
[MASTER COMP/EQ] lights.
2. Press [F2], [F3], or [CURSOR] to select the
parameter.
3. Use [+/-] or [VALUE] to adjust the setting.
4. Press [F1] to turn the master effects on.
Parameter Value
[F2 (M COMP)]
Threshold -60–0 (dB)
Ratio 1:1–100:1
Attack 0–100
Description
Sample rate
Number of bits in data
Cutoff frequency of the
BPF (Band Pass Filter)
Amount of mixing the
sound that goes through
the BPF
Description
Frequency at which
modulation is applied
Description
Volume level at which com-
pression begins
Compression ratio
Time from when the volume
goes up the threshold level
until the compressor effect
applies
Chapter 4. Effect Settings
Parameter Value
Release 0–100
Gain -60– +12
(dB)
[F3 (M EQ)]
Type SHELV
(Shelving),
PEAK
(MID: fixed
to "PEAK")
Q 0.5–8.0
(only when
Type is set
to "PEAK")
Freq (Fre- 20–1k
quency) (LOW), 20–
16K (MID),
1k–16k
(HIGH)
Gain -12– +12
The sound may be distorted in a certain setting.
You can use the master effect on "per kit" basis, or as a
global one (p. 80).
Description
Time from when the volume
falls below the threshold lev-
el until the compressor effect
no longer applies
Output volume of compres-
sor
SHELVE:
Entire range above/below
the selected frequency range
is boosted/cut
PEAK:
The vicinity of the selected
frequency range is boosted/
cut
Width of the frequency
range
A higher Q narrows the af-
fected area.
Point at which the boost/cut
will occur
Amount of boost/cut
43